Mitsubishi Electric M700V Series Manual page 377

17.1.7 PLC Development
17.1.7.1 On-board Development
M720VW
M system ○
L system ○
On-board refers generically to the PLC related operations carried out with the CNC unit.
The Mitsubishi CNC M700V Series on-board realizes functions and operations similar to the MELSEC
Series ladder development tool (GX Developer).
This improves the user's ladder editing operations, and provides an easy-to-use onboard with powerful
ladder monitoring functions.
17.1.7.2 MELSEC Development Tool (GX Developer)
M720VW
M system ○
L system ○
This function enables the data of the PLC contained inside the NC system to be developed and debugged
using the GX Developer installed in a personal computer (OS:Windows).
Many and varied functions of the GX Developer make it possible to reduce the PLC data development and
debugging time.
17.1.8 PLC Parameter
The PLC constants set with the data type and the bit selection parameters set with bit types can be set from
the screen as parameters used by the built-in PLC.
17.1.8.1 PLC Constant (150 Points)
M720VW
M system ○
L system ○
17.1.8.2 PLC Constant Extension (Up to 755 Points)
M720VW
M system ○
L system ○
There are PLC constants that can be set with data types as parameters used by the built-in PLC. The set
data is set in the R register of the PLC and backed up. If data is set in the R register corresponding to the
PLC constant with sequence program MOV commands, etc., the data will be backed up in the PLC constant
parameter. However, the display will not change, so enter another screen, and then select this screen again.
The number of PLC constants is 150 points in the basic area and 755 points at the maximum in the extended
area.
M730VW M750VW M720VS
○ ○
○ ○
M730VW M750VW M720VS
○ ○
○ ○
M730VW M750VW M720VS
○ ○
○ ○
M730VW M750VW M720VS
○ ○
○ ○
M700V Series Specifications Manual
17 Machine Support Functions
M730VS M750VS
○ ○ ○
○ ○ ○
M730VS M750VS
○ ○ ○
○ ○ ○
M730VS M750VS
○ ○ ○
○ ○ ○
M730VS M750VS
○ ○ ○
○ ○ ○
III - 375