Table of Contents
Advertisement
(3) Operation functions
The following operation modes are available. Send a command from PLC to change the operation
mode.
Automatic mode
Manual mode
JOG mode
Manual handle mode
(4) Operation support function
Position switch
The axis is positioned at the station No. designated by the start signal. When the start
signal has turned OFF before the positioning is completed, the axis is positioned at the
nearest station position.
:
The arbitrary position command operation is also available: the positioning can be carried
out to any position other than a station by directly commanding the positioning coordinates
from the PLC.
While the start signal is ON, the axis is rotated at a constant speed in the designated
:
direction. When the start signal has turned OFF, the axis is positioned at the nearest
station position.
While the start signal is ON, the axis is rotated at a constant speed in the designated
:
direction.
:
The axis is moved by the manual PLG.
A signal is output to the PLC interface when the machine has reached within the specified
:
range.
M700V Series Specifications Manual
17 Machine Support Functions
III - 401
Advertisement
Table of Contents
