Mitsubishi Electric M700V Series Manual page 235

12.1.6 Dimension Input
12.1.6.1 Corner Chamfering/Corner R
M720VW
M system △
L system △
This function executes corner processing by automatically inserting a straight line or an arc by the
commanded amount between two consecutive movement blocks (G01/G02/G03).
The corner command is executed by assigning the ",C" or ",R" command for the block at whose end point
the corner is inserted.
(1) Corner chamfering / Corner R I
When ",C" or ",R" is commanded for linear interpolation, corner chamfering or corner R can be
inserted between linear blocks.
Corner chamfering
Example:
N1 G01 Xx1 Zz1 ,Cc1 ;
N2 Zz2 ;
N1 G01 Xx1 Zz1 ,Cc1
N2 Zz2 ;
c 1
N 2
(Note 1) If a corner chamfering or corner R command is issued specifying a length longer than the N1
or N2 block, a program error occurs.
M730VW M750VW
△ △
△ △
;
c 1
N 1
M700V Series Specifications Manual
M720VS M730VS M750VS
△ △
△ △
Corner R
Example:
N1 G01 Xx1 Zz1 ,Rr1 ;
N2 Zz2 ;
N1 G01 Xx1 Zz1 ,Rr1
N2 Zz2 ;
N 2
r 1
12 Program Support Functions
△
△
;
N 1
III - 233