Mitsubishi Electric M700V Series Manual page 146

MITSUBISHI CNC
III Functional Specifications
10.1.4.2 Extended Workpiece Coordinate System Selection (48 Sets) G54.1P1 to P48
M720VW
M system △
L system △
When a multiple number of workpieces with the same shape are to be machined, these commands enable
the same shape to be machined by executing a single machining program in the coordinate system of each
workpiece.
In addition to the six workpiece coordinate systems G54 to G59, 48 workpiece coordinate systems can be
used by assigning G54.1Pn command.
The command format to select the workpiece coordinate system using the G54.1Pn command and to move
on the workpiece coordinate system are given below.
(G90) G54.1Pn G00 Xx1 Yy1 Zz1 ;
G90
G54.1Pn
G00
Xx1,Yy1,Zz1
The numerical value n of P following G54.1 indicates each workpiece coordinate system. Specify a value
between 1 and 48.
The workpiece coordinate zero points are provided as distances from the zero point of the machine
coordinate system.
Settings can be performed in one of the following three ways:
(a) Setting using the setting and display unit
(b) Setting using commands assigned from the machining program
(c) Setting from the user PLC
(Note) While the G54.1Pn (extended workpiece coordinate system selection) is modal, the local
coordinate offset is reduced to zero, and the G52 command cannot be used.
10.1.4.3 Extended Workpiece Coordinate System Selection (96 Sets) G54.1P1 to P96
M720VW
M system ―
L system ―
In addition to the six workpiece coordinate systems (G54 to G59), 96 workpiece coordinate systems can be
used by assigning G54.1Pn command. Refer to "Extended workpiece coordinate system selection (48 sets)
G54.1P1 to P48" for details.
III - 144
M730VW M750VW
△ △
△ △
: (Absolute command)
: Coordinate system selection
: Movement mode
:Coordinate position of end point
M730VW M750VW
△ △
― ―
M720VS M730VS M750VS
△ △
△ △
M720VS M730VS M750VS
― △
― ―
△
△
△
―