Mitsubishi Electric M700V Series Manual page 264

MITSUBISHI CNC
III Functional Specifications
12.1.9.2 Compensation Data Input by Program
M720VW
M system △
L system △
The value of the workpiece coordinate systems selected can be set or changed by program commands.
The tool offset amounts, which have been set from the setting and display unit, can be input by program
commands.
(1) Workpiece coordinate system offset input
The position of the workpiece coordinate systems selected by the G54 to G59 commands can be
set or changed by program commands.
G10 L2 P0
G10 L2 P1
G10 L2 P2
G10 L2 P3
G10 L2 P4
G10 L2 P5
G10 L2 P6
G10 L20 Pn (n=1 to 96)
The format for the workpiece coordinate system setting commands is shown below.
G10 L2(L20) Pp1 Xx1 Yy1 Zz1 ;
G10 L2(L20) : Workpiece coordinate system setting command
Pp1 : Workpiece coordinate system No.
Xx1,Yy1,Zz1 : Setting values
(Note 1) L2 can be omitted. Omitting Pp1 results in a program error. [M system]
(Note 2) L20 is used to designate the extended workpiece coordinate system.
III - 262
M730VW M750VW
△ △
△ △
Gcode
External workpiece coordinate system setting
Workpiece coordinate system 1 setting (G54)
Workpiece coordinate system 2 setting (G55)
Workpiece coordinate system 3 setting (G56)
Workpiece coordinate system 4 setting (G57)
Workpiece coordinate system 5 setting (G58)
Workpiece coordinate system 6 setting (G59)
Extended workpiece coordinate system setting (G54.1 P1 to
P96)
M720VS M730VS M750VS
△ △
△ △
Function
△
△