Mounting The Npd On The Gc; Jet For Npd - Thermo Scientific TRACE GC Ultra Installation Manual

Getting Started

Mounting the NPD on the GC

This operation allows the correct installation of the NPD on your TRACE GC
Ultra.
Material needed
•
•
1. Place the jet into the detector base body housing and tighten it with the proper
2. Install the NPD on the detector base body and secure it by using the fixing
3. Carefully, connect the signal and ignition polarization cables coming from the
Installation Guide

Jet for NPD

Tool for jet
tool. Ensure the jet is perfectly vertically aligned to avoid damaging its
ceramic part. Refer to Figure 1-12.
1. Tool for jet
3. Detector base body
screw on the front of the detector cell. Refer to Figure 1-13 on page 22.
detector control card, to the detector cell. Refer to Figure 1-13 on page 22.
1
2
3
2. Jet
Figure 1-12. Jet for NPD
Upgrade Kit
Nitrogen Phosphorus Detector
21