Thermo Scientific TRACE GC Ultra Installation Manual page 27

Set NPD Parameters
1. These settings could also be for a right detector.
2. If you have a non-DGFC module, the actual value are not displayed, and you can only turn the
flows on and off.
2. To open NPD Signal menu, press LEFT SIGNAL or RIGHT SIGNAL according
1. These settings could also be for a right signal
Installation Guide
to the location of the detector. The following menu is displayed:
Output
Offset
Auto zero?
Range 10^(0..3)
Analog filter
Baseline comp
LEFT SIGNAL (NPD)
Nitrogen Phosphorus Detector
1
(1000)
100
Y/N
0<
Off
Off
Upgrade Kit
27