Thermo Scientific TRACE GC Ultra Installation Manual page 15

Getting Started
WARNING! The jumper marked "Jx" must be positioned between the pins 2 and 3.
3. Guide through the slot mentioned at point 1 the signal and ignition cables
4. Plug the detector control card into the selected expansion slot on the mother
5. Fix the control card by using the same screw previously removed at point 1.
Installation Guide
Pins 1-2 = additional heat control enabled
Pins 2-3 = additional heat control not enabled
coming from the top of the card.
board.
Jumper Positioning
Upgrade Kit
Nitrogen Phosphorus Detector
15