Table of Contents
Advertisement
Upgrade Kit
Nitrogen Phosphorus Detector
Reinstall the Power Control Module
CAUTION
This operation requires particular attention because several cables must be
reconnected to the Power Control Module. It must be gradually reinserted paying
attention to reconnect step by step all the cables until the power control module is
completely reinstalled into the GC.
1. Reconnect the previous disconnected connections in the reverse order of their
2. Secure the six Phillips screws that fix the Power Control Module in place.
3. Reconnect the chassis ground wire to the GC rear oven terminal.
20
Figure 1-11. Installation of the Transformer for NPD
removal.
Getting Started
Installation Guide
Advertisement
Table of Contents
