HBM DMP41 Operating Manual page 79

DMP41
7.3 Device configuration in setting mode
Important
The device is set up via the menus under Device.
If the device is in measuring mode:
► Press shift key F1 to switch to setting mode (Settings).
7.3.1 Password
You can password-protect all the settings of your DMP41.
This password protection (for working directly on the DMP41) is switched off
in the factory setting.
If the DMP41 is operated via a PC, it is always necessary to enter a pass­
word.
As soon as password protection is activated, the password must be entered
whenever the DMP41 is restarted. Only then can the settings be edited.
The password only needs to be entered for the zeroing, taring and min/max
functions in measuring mode.
Administrator rights apply to:
S the person who entered the password
S the person working directly on the DMP41 (default)
A03470_07_E00_00 HBM: public
Configuration
Device configuration in setting mode
79