Table of Contents
Advertisement
Settings and assembly instructions
15
Adjusting the sternum harness
Notes on the correct adjustment of the sternum harness are found in the instructions for use (user) of this power
wheelchair and the instructions for use included with the belt system.
6.2.8 Adapter for head/neck support mounting kit
16
6.2.9 Crutch holder
17
16
Installing the sternum harness on the upper back
support tube
1) Pre-install two tube clamps on the back support
tube, each at a distance approximately equal to the
width of the belt straps (see fig. 15, item 1/2).
2) Pass the upper belt straps of the sternum harness
around the back support tube between the tube
clamps (see fig. 15, item 3).
3) Attach the belt straps to the back support tube with
the glide buckles (see fig. 15, item 4). The belt
straps have to be tight against the back support
tube.
4) Push the tube clamps on the back support tube
tight against the belt straps from the left and right
(see fig. 15, item 1/3). Firmly tighten the Allen
screws and cap nuts of the tube clamps (see
fig. 15, item 2).
1) Mount the adapter plate on the back support tube
using the two supplied Allen head screws (see
fig. 16, item 1). Tighten the Allen head screws to
10 Nm.
2) Now a head support mounting kit can be installed
(not included in the scope of delivery).
Installing the loop, preparing the component group
1) Loosen the Phillips head screw and install the loop
of the crutch holder on the back support tube (see
fig. 17, item 1).
2) Prepare the component group. To do so, connect
the retaining plate and the crutch holder (see
fig. 17, item 2/3). Firmly tighten the supplied Allen
head screws with the cap nuts (see fig. 17, item 4).
490E163=*
Advertisement
Table of Contents
