Table of Contents
Advertisement
NOTICE
Incorrect cable routing
Plug connections coming loose or damage to the cables due to assembly errors
► Take note of the cables attached to the product with cable ties during all assembly work.
► Carefully cut the cable ties with suitable side-cutting pliers if necessary. Ensure that you do not damage the
cables during this process.
► Install the cables in such a way that they cannot be damaged. Leave an appropriate cable loop on moveable
components so they can move without tension.
► Only use suitable fasteners (such as cable ties). Also use cable ties to secure the plug connections to the
product so they cannot be disconnected unintentionally.
3.4 Programming safety instructions
WARNING
Incorrect configuration of the control device
Falling, tipping over, collision due to incorrect parameter settings
► Note that modified parameter settings lead to changes in driving characteristics. In particular, changes to the
speed, acceleration, braking or joystick settings can lead to unexpected and therefore uncontrollable driving
characteristics and cause an accident.
► The parameter settings of the control device may only be changed by qualified personnel. The manufacturer of
the product and the control device manufacturer are not liable in case of damage caused by parameter set
tings that were incorrectly configured or not adjusted properly according to the user's abilities.
► The user must test the driving characteristics of the product under the supervision of the qualified personnel
each time after parameter settings are changed.
3.5 Safety instructions regarding maintenance and repairs
CAUTION
Damage to the product, unexpected noise or odours
Health problems for the user
► Report damage to the product that may cause health problems for the user to Ottobock. This includes uncon
trolled movements of the product as well as sounds that are unexpected or previously not noted or odours that
deviate significantly from the state of the product at the time of delivery.
3.6 Further information
INFORMATION
The serial number required for enquiries and ordering spare parts and accessories is found on the nameplate.
For explanations of the nameplate, see the section "Nameplate" (see page 7).
3.7 Nameplate
The nameplates are found on the side of the frame under the seat.
Label
490E163=*
A Manufacturer's product name
B CE marking
C Maximum load (see section "Technical data")
D Maximum climbing ability (see section "Technical data")
E Maximum speed (see section "Technical data")
F Allowable axle load, front
G Allowable axle load, rear
H Allowable overall weight
I
Manufacturer information/address
1)
J
Serial number
K Manufacturing date
L Symbol for medical device
Meaning
2)
Safety
7
Advertisement
Table of Contents
