Table of Contents
Advertisement
18
6.2.10 Storage bag
CAUTION
Product contains magnets
Crushing due to incorrect handling
► Magnets have a powerful attractive force and can cause crushing if handled without due care. Watch out for
fingers or skin in the closure area.
19
20
490E163=*
Installing the crutch holder component group on
the anti-tipper
1) Remove the anti-tipper roller (see fig. 18, item 1).
2) Affix the supplied loop strap to prevent rattling (see
fig. 18, item 2).
3) Slide the crutch holder component group onto the
anti-tipper tube (see fig. 18, item 3).
4) Insert the screw of the anti-tipper roller from the
inside through the retaining plate of the crutch hold
er and through the anti-tipper tube (see fig. 18,
item 4).
5) Reinstall the anti-tipper roller on the outside (see
fig. 18, item 1). Tighten the Allen head screw/cap
nut so the anti-tipper roller is tight but still turns.
Preparing the storage bag
1) Insert the small plates into the side pockets of the
storage bag. The slotted hole faces up on each side
(see fig. 19, item 1).
2) Install the retaining plates on the small plates using
the supplied mounting materials (see fig. 19,
item 2). The pointed sides of the retaining plates
face forward in the direction of travel during sub
sequent assembly (see fig. 19, item 3).
Attaching the storage bag
1) Remove the seat cushion.
2) Determine the appropriate mounting points under
the seat plate (see fig. 20, front: item 1; rear:
item 2).
3) Attach the retaining plates of the storage bag on the
chosen mounting points of the seat plate. Tighten
the screw connection to 10 Nm (see fig. 20,
item 1/2).
4) Replace the seat cushion.
Settings and assembly instructions
17
Advertisement
Table of Contents
