Use In Vehicles For Transporting Persons With Reduced Mobility - Otto Bock Dino 3 Instructions For Use Manual

46

7.15 Use in vehicles for transporting persons with reduced mobility

WARNING
Use in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► Always use the seats and personal restraint systems in the vehicle for transporting persons with reduced
mobility first. This is the only way to ensure optimum protection of passengers in the event of an accident.
► If the product is to be used as a seat in a vehicle for transporting persons with reduced mobility, the safety
elements offered by the manufacturer and appropriate fastening and personal restraint systems must be used.
For more information, please refer to our brochure with the order number 646D158.
► Never transport more than one person in the product.
► Only use the product in a vehicle for transporting persons with reduced mobility with the back support in a
vertical position.
► Observe the limitations regarding installed options (see Page 38).
WARNING
Use of the belt system as a passenger restraint system in vehicles for transporting persons with reduced
mobility is forbidden
Serious injuries due to improper handling of the product
► Under no circumstances may the belts and positioning aids offered with the product be used as part of a pas­
senger restraint system in vehicles for transporting persons with reduced mobility.
► Note that the belts and positioning aids offered with the product are only intended to help support the user sit­
ting in the product.
WARNING
Prohibited transportation with activated back support angle adjustment/seat tilt
Loss of safe restraint in the product due to user error
► Ensure that the passenger is sitting upright during transportation.
► Move the back support to the upright position and the seat tilt to the horizontal neutral position (0°) prior to
travel.
► Check the locking mechanism on both sides.
The product has been tested by the manufacturer according ISO 7176-19 and may be used as a seat in vehicles
for transporting persons with reduced mobility subject to the conditions defined below.
The product must be sufficiently secured during transport in vehicles for transporting persons with reduced mobil­
ity. The illustrations that follow show an example for anchoring in a motor vehicle.
The manufacturer is not responsible for the fastening systems that are used. Ensure that only fastening systems
that meet the applicable legal requirements and are designed for the overall weight of the product including the
user are used.
The transport weight of the person being transported in a vehicle for transporting persons with reduced mobility is
limited to the maximum total load capacity (weight with seating shell). Further information: see Page 43
Dino 3
47
Use
35