Otto Bock Dino 3 Instructions For Use Manual page 12

Safety
Hazards due to incorrect air pressure and defective tyres
CAUTION
Incorrect air pressure
Uncontrolled driving characteristics, falling, tyre rupture due to incorrect inflation
► Maintain sufficient air pressure in pneumatic tyres. Do not exceed the permitted specifications when filling the
tyres (see Page 43).
► Do not use the product with over/under-inflated or unequally inflated tyres.
► Note that a single tyre with low air pressure can lead to uncontrolled driving characteristics.
► Note that low pressure of the rear wheels / drive wheels can reduce the braking force of the knee lever wheel
lock.
CAUTION
Defective tyres
Accidents/falls due to poor traction, reduced braking force or lack of manoeuvrability
► Ensure that the tyres have sufficient tread depth.
► Ensure that the knee lever wheel lock is properly adjusted (approx. 5 mm gap to the tyre, technical changes
reserved).
Hazard in case of broken skin
CAUTION
Skin damage
Skin damage or pressure points due to overloading
► Check your skin for intactness before and during use of the product.
► Pay attention to diligent skin care and pressure redistribution during interruptions in using the product.
► If skin damage or other problems occur during use, stop using the product. Consult the qualified personnel.
Hazards due to fire, heat and cold
CAUTION
Extreme temperatures
Hypothermia or burns due to contact with components, failure of components
► Do not expose the product to any extreme temperatures (e.g. direct sunlight, sauna, extreme cold).
► Do not leave the product in the immediate vicinity of heaters.
Hazards due to improper use of the product
WARNING
Overloading
Severe injuries if the product tips over due to overloading, damage to the product
► Do not exceed the maximum load capacity (see the nameplate and section "Technical data").
► Please note that certain accessories and add-on components will reduce the remaining load capacity.
WARNING
Exceeding the service life
Serious injuries due to failure to observe the manufacturer's requirements
► Using the product beyond the specified expected service life leads to increased residual risk.
► Observe the specified service life.
CAUTION
Use of the product during diagnostic examinations and therapeutic treatment
Impairment of the examination results or the effectiveness of treatment due to interactions of the product with
devices that are used
► Make sure that examinations and treatments are carried out exclusively under the prescribed conditions.
12 Dino 3