Special Features For Wheels With Pu Tyres; Disposal; Disposal Information; Legal Information - Otto Bock Dino 3 Instructions For Use Manual

Disposal

55
Inflating the tube
1) Ensure that the valve is positioned perpendicularly for proper positioning of the tube and tyre in the region of
the valve.
2) Firmly screw on the valve nut.
3) Inflate the tube so that the tyre can still be pressed in easily with your thumb.
INFORMATION: If the circumferential lines on the two sides of the tyre are both at an even distance
from the rim, the tyre is centred. If not, let some air out and realign the tyre.
4) Inflate the tube to the maximum pressure specified by the tyre manufacturer (see information printed on the tyre
sidewall).
5) Firmly screw the valve cap onto the valve.

8.2.2 Special features for wheels with PU tyres

If the PU tyres have to be replaced, the entire wheel also has to be replaced on both sides (in pairs).
9 Disposal

9.1 Disposal information

Return the product to the qualified personnel for disposal.
All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.

10 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.

10.1 Liability

The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.

10.2 Warranty

Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit­
ted this product or the manufacturer's service (see inside back cover for addresses).

10.3 Service life

Expected lifetime: 4 years
The design, manufacturing and requirements for the intended use of the product are based on the expected life­
time. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.
42
56
Dino 3