Use; Instructions For Use - Otto Bock Dino 3 Instructions For Use Manual

Use

WARNING
Failure to verify readiness of use prior to putting into operation
Falling, tipping over, serious injuries due to incorrect adjustment or installation
► Before you start using the product for the first time, check the chosen product settings with the support of
qualified personnel.
► After every assembly of drive wheels with a quick-release axle, check that they are properly mounted. The
quick-release axles must be firmly locked in the drive wheel attachment.
► Check the seating position centre of gravity. It must be set so that activating the seat tilt release lever allows
the seat to be adjusted easily. Contact the qualified personnel if necessary.
→ Centre of gravity too far forward: The user could tip forward when the seat is tilted.
→ Centre of gravity too far back: The user could tip backwards when the seat is tilted.
► In particular, verify tip resistance, easy operation of the wheels and correct brake functionality.
► For pneumatic tyres: Check the tyre pressure. For correct air pressure: see Page 43 ff. Ensure that the pres­
sure is the same in both tyres.
► Verify that the knee lever wheel lock settings are correct (approx. 5 mm gap to the tyre, technical changes
reserved).
INFORMATION
On the topic of disassembly/transport: see Page 34.
A few simple steps are sufficient to prepare the product for use:
1) If present: Remove the transport locks and packaging material.
INFORMATION: Save the packaging in case transportation is subsequently required.
2) For plug-on drive wheels: Attach the wheels to the drive wheel attachment device (see fig. 4).
The quick-release axles must not be removable after releasing the push-button.
3) Attaching the seating shell/seating solution:
→ Ottobock Shape seating solution: Mounted prior to delivery by the qualified personnel that adapted the
mobility base for seating shells.
→ Seating solutions from other manufacturers: Mounted according to the individual specifications of the
qualified personnel.
→ Further information on attaching seating solutions with a parallel adapter/trapezoid adapter: Section
"Removing/attaching the seating shell/seating solution (see Page 21)
4
7 Use

7.1 Instructions for use

• Attaching loads (e.g. backpacks) can adversely affect stability. Therefore, suspending additional loads on the
product is not permitted.
• The recommended overall width for manual wheelchairs or comparable products in an operational state is
700 mm. This specification should ensure unhindered use of escape routes, for example. Please note that the
product dimensions can exceed the recommended value in versions with very large seat widths (for more
information see see Page 43 ff.).
16 Dino 3