Agilent Technologies B2200A User Manual page 51

Femto leakage switch mainframe; 14ch low leakage switch mainframe
Table of Contents

Advertisement

Figure 2-6
The 4155/4156 semiconductor parameter analyzer's Intlk connector provides the
interlock signal and a LED drive signal. If a LED is connected between pin 4 and
pin 5 (or 6) of the interlock connector, the LED lights to indicate high voltage output
when more than ±40 V is forced from an SMU in the 4155/4156.
Dimensions of LED (Agilent part number 1450-0641)
6
Units: mm
To Connect Interlock Circuit to Instrument
Before beginning the measurement, connect the interlock circuit to the instrument's
interlock connector as follows.
For the instruments which has a BNC-Type interlock connector:
1. Get the following parts.
Agilent 16493J Interlock cable, 1 ea.
Agilent 16435A Interlock cable adapter, 1 ea.
2. Connect the 16493J interlock cable between the interlock circuit and the
16435A adapter.
3. Connect the BNC cable (furnished with the adapter) between the adapter and
the instrument's interlock connector.
For Agilent 4155/4156/E5260/E5270:
Connect the 16493J interlock cable between the interlock circuit and the
instrument's interlock connector. You can connect it directly without using any
adapter.
Agilent B2200 User's Guide, Edition 2
Output Connections
5
5.6
Installation
2-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

B2201a

Table of Contents