[:Route]:Agnd:channel:enable[:List] - Agilent Technologies B2200A User Manual

Syntax
Example
Syntax
Query response
Example
SCPI Command Reference

[:ROUTe]:AGND:CHANnel:ENABle[:LIST]

[:ROUTe]:AGND:CHANnel:ENABle:CARD card_number
Parameter
card_number
OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB:CARD ALL"
[:ROUTe]:AGND:CHANnel:ENABle[:LIST]
This command specifies the ground-enabled output ports (channels). When the
Ground Mode is ON, the ground-enabled output ports that have not been connected
to any other input port are connected to the input Ground Port. Then, the input
Ground Port will not be connected to the output ports that have been connected to
any other input port. At *RST, no channel is ground-enabled. The ground mode is
set by "[:ROUTe]:AGND[:STATe]".
The query returns whether the specified channels are ground-enabled or not.
[:ROUTe]:AGND:CHANnel:ENABle[:LIST] (@channel_list)
[:ROUTe]:AGND:CHANnel:ENABle[:LIST]? (@channel_list)
Parameter
channel_list
Input port is always the input Ground Port. So, the input ports in channel_list are
ignored. However, you cannot abbreviate the input port number.
enable_status{, enable_status} <newline><^END>
1: ground enabled
0: ground disabled
OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB (@10101)"
OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB? (@10101,10102,10201)"
ENTER @Agb2200;A$
This example ground-enables the output port 1 on the card 1. In this example, A$
will be 1,0,1.
5-26
Explanation
For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Explanation
Channels to ground-enable or to check.
For channel_list, see "Switch Control" on page 4-5.
Agilent B2200 User's Guide, Edition 2