Auto Power-Off; Squelch Delay - Icom IC-2100H Instruction Manual

14
OTHER FUNCTIONS

Auto power-off

The auto power-off function conveniently turns the transceiver
power OFF after a preset time in which no operations are per-
formed. In this way, if you forget to turn power OFF, the trans-
ceiver automatically turns itself OFF.
The time can be set to 30 min., 1 hr., 2 hr. or turned OFF. The
selected time is retained even when the transceiver is turned
OFF via the auto power-off function. To cancel the function,
select "OF" in step
Push [PWR] to turn power OFF.
While pushing [SET], turn power ON to enter initial set
mode.
Push [SET] one or more times until "POF" appears.
• Pushing [MONI] reverses the order of selection.
Rotate the tuning dial to se-
lect the desired auto power-
off time or turn the timer
OFF ("OF").
• "AO" appears when an auto
power-off time is set.
Push [PWR] to exit initial set mode.
56
INITIAL SET MODE
USING
below.
AO
The display shows that the
30 min. timer is selected.

Squelch delay

During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-
2100H has a built-in squelch delay function which helps pre-
vent this. When both stations are operating from a fixed
location e.g. during packet operation, this function should be
set to "short."
Push [PWR] to turn power OFF.
While pushing [SET], turn power ON to enter initial set
mode.
Push [SET] one or more times until "SQT" appears.
• Pushing [MONI] reverses the order of selection.
Rotate the tuning dial to set the squelch delay to "L" (long)
or "S" (short).
Push [PWR] to exit initial set mode.
INITIAL SET MODE
USING