Setting A Frequency; Preparation - Icom IC-2100H Instruction Manual

Preparation

D Turning power ON/OFF
NOTE: Before operating the transceiver for the first time
it's a good idea to reset the transceiver's CPU. This will en-
sure that all transceiver settings are at their defaults. See
p. 62 for CPU resetting details.
Push [PWR] for 1 sec. to turn power ON or OFF.
Push [PWR] for 1 sec.

SETTING A FREQUENCY

D VFO and memory modes
The transceiver has 2 basic operating modes: VFO mode and
memory mode.
Push [V/MHz] to select VFO mode when the transceiver is
not in VFO mode.
• If VFO mode is already selected, the digits below 100* kHz disap-
pear. In this case, push [V/MHz] again (or push twice or 3 times de-
pending on version).
*The digits below 1 or 10 MHz disappear for some versions.
1
VFO mode is selected.
Push [VFO] to select VFO mode.
VFO
Note that in this manual, sections beginning with
a microphone icon (as above), designate opera-
tion via the HM-98S microphone.
9
5
Appears when memory mode
is selected.
3
9
5
1
M
13