Additional Components Required; Control Elements - Otto Bock Instructions for us Instructions For Use Manual

Product Description

2.4 Additional Components Required

The required 743A11 Casting Apparatus and the SIT-Cast Casting Device, which is available in the versions
743G10 and 743G1, are not included in the scope of delivery. These must be ordered separately.

2.5 Control Elements

1.1
1.2
2.1 2.2
1 2 3
The adjustment wheels (1 + 5) are used to adjust the position and angle of the tuberosity supports (4). Consult the
illustration above for the effect that turning the adjustment wheels has on the tuberosity supports.
The frontal support (3) can be adjusted after loosening the knurled screw (2). Afterwards re-tighten the knurled
screw.
When adjusting the position of the tuberosity supports (4), first use the adjustment wheel (5) to set the approximate
position. Then use the other adjustment wheel (1) to fine-tune the angle. Finally, adjust the position of the frontal
support (3).
22 | Ottobock
Item no. Designation
1 Anatomical SIT-Cast 743Y50
2 Casting Apparatus
3 Pneumatic SIT-Cast
1
Casting Device
- SIT-Cast
Device
(same
2
without pneumatics)
3
1.1
1.2
1.1 1.2
4
Article number
743A11
743G10
Casting 743G1
as 743G10
5.2
5.1
5.2 5.1
743Y50 Anatomical SIT-Cast
5.1
5.2
5