Table of Contents
Advertisement
NOTE:
4.1.8 Signal Adjust
The signal strength and quality bar on the bottom of the screen allows you to fine tune the alignment
of your antenna for optimum reception. Adjust your antenna for maximum possible signal strength and
quality. When the signal cannot be improved anymore, fix the dish on this position, and press the BLUE
button for Search options and scan.
Highlight Search, press the OK button to start channel scan automatically.
4.1.9 Search
Your receiver will now perform an automatic channel search. When the process has been completed, all
found channels will be stored and the receiver will switch to the first found channel. You are now ready to
enjoy your new receiver.
NOTE:
5.0 QUICK GUIDE FOR USING YOUR RECEIVER
We at STRONG understand that you can't wait to enjoy your new HD receiver. The following quick guide
will make you familiar with the basic operation of this device. We do, however, advice you to read the full
manual to get the best performance from your STRONG HD receiver.
To turn your receiver ON or to Standby, press q on the remote control.
Choose channels with pq. Alternatively, you can also enter the channel number with the 0~9 buttons
on the remote control or press OK in viewing mode to display the channel list.
The volume can be adjusted with t u or with the dedicated VOL+/VOL- buttons.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter 7 to get familiar with the menu of your new receiver.
6.1 Changing channels
There are different ways to change channels with your new receiver.
Via direct access
„
Via the channel list
„
Via the pq buttons
„
Via the 9 button
„
Via the CH+/CH- buttons
„
10
Scrambled channels cannot be watched with this receiver. Select if you
want to store TV and radio channels, only TV or only radio. Select network
search Yes if you only want to store channels which belong to one provider.
These channels are usually scrambled.
If no channels were found during the automatic channel scan, the receiver
will return to Installation guide menu. Please select your language again and
refer to chapter 7.1 for further instructions.
Advertisement
Table of Contents
