Table of Contents
Advertisement
Make sure that the SCART/HDMI cable and outdoor components are in a good condition and
„
the SCART/HDMI connections are well shielded and from good quality.
This manual provides complete instructions for installing and using this receiver. The symbols serve as
follows.
WARNING
Indicates warning information.
NOTE
Indicates any other additional important or helpful information.
MENU
Represents a button on the remote control or the receiver.
(Bold characters)
Move to
Represents a menu item within a window.
(Italic characters)
1.4 Accessories
1x installation instructions
„
1x Safety and guarantee instructions
„
1x remote control
„
2x batteries (AAA type)
„
NOTE:
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„
specifications, multimedia, recording and Timeshift functions of the receiver might not work
properly.*
If you are going to use an external USB HDD (Hard Disk Drive), please consider that the power
„
specifications may exceed the supported output of your receiver (5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
It is advised not to store important information on USB storage devices used with the receiver.
„
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends
„
on file size, codec, bit rate and resolution.
Please ensure that either the USB device is already formatted to FAT/FAT32, or format the USB device via
your receiver, refer to chapter 7.3.6.1 PVR Storage Information
for details.
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording
via USB has not yet been installed.
4
The batteries should not be recharged, disassembled, electrically short-
circuited or be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
Advertisement
Table of Contents
