Dish Setup; Quick Guide For Using Your Receiver - Strong SRT 7010 User Manual

NOTE
You can continue to Channel search and install further channels as described below or directly go to
viewing mode by pressing OK to start enjoying the pre-installed channels immediately.

4.1 Dish setup

4.1.1 Satellite Selection
Use p/q to highlight the satellite your dish is aimed at. When using a multi feed antenna with more
than 1 LNB, select the satellites your antenna is adjusted for by pressing OK and set the appropriate
LNBs in the right-hand screen by pressing u at the DiSEqC 1.0 or, if applicable, DiSEqC 1.1 option. The
scan process will then search on all selected satellites. If using motorized antennas or SatCR, please
refer to chapter 7.
4.1.2 Signal Adjust
The signal Strength and Quality bar on the bottom of the screen allows you to fine tune the
alignment of your antenna for optimum reception. Adjust your antenna for maximum possible signal
strength and quality. When the signal cannot be improved anymore, fix the dish on this position and
press the BLUE button for Scan options and scan.
4.1.3 Scan Mode
Use p/q to highlight the options of choice and press BLUE to start the scan. It is recommended to
use the default settings.
4.1.4 Scan
Your receiver will now perform an automatic channel search. When the process has been completed,
all found channels will be stored and the receiver will switch to the first found channel. You are now
ready to enjoy your new receiver.
NOTE

5.0 QUICK GUIDE FOR USING YOUR RECEIVER

We at STRONG understand that you can't wait to enjoy your new HD receiver. The following quick
guide will make you familiar with the basic operation of this device. We do, however, advice you to
read the full manual to get the best performance from your STRONG HD receiver.
To turn your receiver ON or to Standby, press q on the remote control.
If Germany or Italy is selected as country, a pre-installed channel list is
available. German channels from ASTRA 19.2E will be installed. Italian
channels from Hotbird 13E will be installed.
If no channels were found during the automatic channel scan, the receiver
will return to Installation guide menu. Please select your language again
and refer to chapter 7.3 for further instructions.
9