Strong SRT 7030 User Manual page 13

4.1.3 Satellite List
Press p or q button to highlight satellite, press OK button select a satellite. A heart symbol will mark the
selected satellite(s).
RED button: Edit satellite
GREEN button: Add satellite
BLUE button: Delete satellite
4.1.4 Antenna Setup
Motor Antenna:
If you selected Motor Antenna in Antenna Connection menu, this menu allows you to change
settings like LNB frequency, motor type, local longitude/local latitude, delete all,
motor setting and limit setup.
Fixed Antenna:
If you selected Fixed Antenna in antenna connection menu, this menu allows you to change settings like
satellite, LNB frequency, transponder, DiSEqC 1.0, DiSEqC 1.1, 22kHz, and polarity.
When settings are correct, press  to return to DVBS installation menu.
4.1.5 Single Satellite Search
To scan 1 satellite:
Select Satellite, FTA only, Scan Channel, Network Search, Scan Mode and Tuner to your requirements.
Highlight Search and press OK button to start search on the selected satellite.
4.1.6 Multi Satellite Search
To scan more than 1 satellite:
Adjust FTA Only, Scan Channel, Network Search, Scan mode and Tuner to your requirements.
All satellites selected in the satellite list are shown in the top line.
Highlight Search and press OK button to start searching on all satellites selected in the satellite list.
4.1.7 Transponder List
If needed, transponders can be edited, added, deleted, or individually searched. Parameter of satellite
transponders can be changed by broadcasters over time.
RED button: Edit TP
GREEN button: Add TP
YELLOW button: Delete TP
BLUE button: Search Channels
Press t u button to change satellite.
Press p or q button to select Transponder.
Select the Search option, press OK button to enter the auto scan menu.
Press the cursor button to set FTA only Yes or No. (FTA = Free to Air, Free to watch.)
9