Table of Contents
Advertisement
7.1 Installation menu
7.1.1 Installation
Here you can setup your dish and satellite parameters. Enter the menu via the Installation In this menu
setting will be automatically stored upon exit without the need of confirming.
Antenna Connection
Enter here to select the type of satellite dish or antenna you have: Either a fixed antenna or a motor
antenna
Satellite List
In this menu you can select the satellites for which you have a particular interest, like if they carry
programmes which are especially aiming at your country. In the satellite search menu's, these satellites
can be searched to obtain programs.
Select one or more satellite from the list to search with OK. A heart symbol will appear behind the name.
To deselect, press OK again.
In case you need to make manual changes to the satellites present in the default list:
To Edit the Satellite name and position press RED. Use the numeric buttons to enter characters. Confirm
with YELLOW.
To Add a Satellite, press GREEN. Use the numeric buttons to enter characters to enter a new Satellite's
name and position. Confirm with YELLOW.
To Delete a Satellite, select the Satellite from the list and press BLUE. Confirm the pop-up screen.
Antenna Setup
In this menu you can enter the Dish parameters, depending on the selection in Antenna Connection
for Fixed Antenna or Motor Antenna and Satellites selected in the Satellite List
Satellite
LNB
SatCR LNB's are used for SatCR systems, mainly in apartment blocks. Enter the IF channel number
according the assigned (user band), then the corresponding centre frequency. If the system only
supports one satellite, sat position is 1. The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to
8 different users, version 2.0 can have up to 32, it depends on the LNB used.
SatCR systems are usually installed by professional experts. An optional satellite splitter is required for
multi-users.
NOTE:
Transponder
DiSEqC1.0:
Shows the Satellites selected in the Satellite List
Press OK to view a pull down list with the selected satellites
Press t u or OK to show the list of LNB Types. The Universal LNB frequencies
(09750/10600 MHz) are supported – the most used on the market.
For SatCR use, DiSEqC and polarity should be disabled.
Select a known transponder to help you find a satellite, or to check if the
settings you've entered are correct. Use the signal intensity and signal quality
bars to fine tune your dish, if needed.
To select the correct port from up to 4 (if available) for the corresponding LNB.
For committed DiSEqC switches only.
13
Advertisement
Table of Contents
