Strong SRT 7030 User Manual page 21

Scan Channel:
Scan Mode:
Auto Scan
Pre-set Scan
Accurate scan
Network Search
Tuner
After configuring, select Search and press OK to start scanning with the selected settings.
Your receiver will now perform an (automatic) channel search with the scanning progress shown on
screen. During the channel search you can quit the scan process with . When the process has been
completed, all found channels will be stored. Press OK to confirm and leave the menu by pressing with
 several times, or proceed to editing parameters by pressing  only once.
Multi-Satellites Search:
To scan more than one satellite in one go.
These must have selected before in the Satellite List.
The procedure is the same as for Single Satellite Search, except for the Satellites mentioned in the top line.
All those will be scanned one after the other.
7.1.5 Transponder Edit Options
Scanning by transponder (Manual Scan)
Select TP List in the Installation menu.
The transponder list is shown for the in the top line selected satellite.
Search
Options are:
FTA Only:
Scan Channel:
Network Search
Press t u to select TV+Radio, TV Channel or Radio
Use t u to select mode auto scan, pre-set scan or accurate Scan}.
This the default mode and should be used first.
All stored transponders in the memory will be scanned.
A few satellites carry a list with transponder parameters of all transponders
on that satellite. It can be useful if the auto scan does not find an expected
channel.
This is a blind scan mode, in which the scan process probes certain
frequencies to find unknow parameters of a Satellite.
Use t u to select Yes or No. Some providers use more than one transponder
to transmit their Pay-TV programmes. Select Yes and one of those
transponders and it will find the corresponding transponders as well. Note:
This is only applicable for scrambled channels, which can not be seen with
this receiver.
Not applicable for this receiver.
Use the pq buttons to highlight the transponder you want to scan and
press OK or BLUE for Search. A window with scanning settings will be
displayed. After configuring the settings press OK to start the scanning of the
highlighted transponder. When the scan process has been completed, all new
found channels will be added to the end of the channel list.
Press t u to select No to search for (scrambled and free) channels or {Yes to
search for Free to Air channels only.
NOTE: Scrambled channels can not be watched with this receiver.
Press t u to select TV+Radio, TV Channel or Radio
Use t u to select Yes or No. Some providers use more than one transponder
to transmit their Pay-TV programmes. Select Yes and one of those
transponders and it will find the corresponding transponders as well. Note:
This is only applicable for scrambled channels, which can not be seen with
this receiver.
17