Checking The Piston Ring End Gap; Measuring The Piston/Cylinder Mounting Clearance - Husqvarna FE 450 2014 Repair Manual

18.4.17

Checking the piston ring end gap

18.4.18

Measuring the piston/cylinder mounting clearance

-
Measure the piston at the piston skirt, parallel to the gudgeon
pin.at a distance of 6).
Guideline
0
Distance
Piston - diameter
Size I
Size II
Info
Piston dimensions
-
Remove the piston ring from the piston.
-
Place the piston ring in the cylinder and align with the piston.
Guideline
Below the upper edge of the
cylinder
-
Using special tool
Guideline
Piston ring end gap
304694-10
Compression ring
Oil scraper ring
I
Feeler gauge (59029041100)
If the end gap is greater than the specified value:
-
Check/measure the cylinder.
If cylinder wear lies within the specified tolerance:
-
Change the piston ring.
-
Mount the piston ring with the marking facing upward.
-
Check/measure the cylinder.
-
Check/measure the piston.
-
The smallest piston/cylinder mounting clearance equals the
smallest cylinder bore diameter minus the largest piston
diameter. The largest piston/cylinder mounting clearance
equals the largest cylinder bore diameter minus the smallest
piston diameter.
304609-10
7 mm (0.28 in)
94.93 ... 94.96 mm (3.7374
... 3.7386 in)
94.94 ... 94.97 mm (3.7378
... 3.739 in)
O
are marked on the piston head .
10 mm (0.39 in)
O.
measure the end gap.
I
:S 1 .00 mm (:S 0.0394 in)
I
:S 1.20 mm (:S 0.0472 in)
(il!ll p. 314)
(il!l p. 185)
(l!.ll p. 185)
(l!.ll p. 186)
18 ENGINE
..
187