Husqvarna FE 450 2014 Repair Manual page 180

18 ENGINE
178
Info
Any bearings that remain in the section of the engine
case must be removed using a suitable tool.
Press out the crankshaft shaft seal ring @ from the inside
toward the outside.
Press in the shaft seal ring from the outside toward the
inside, with the open side facing outward.
Info
The shaft seal ring must be flush on the outside.
-
Warm the engine case section again.
Guideline
1150 °c (302 °F)
Insert the new cold bearings in the bearing seats of the
heated section of the engine case; if necessary, use a
suitable press drift to push them all the way in and make
them flush.
Info
When pressing in, ensure that the section of the
engine case lies flat in order prevent damage.
Only press the bearings in using the outer bearing
race; otherwise, the bearings will be damaged when
they are pressed in.
-
After the section of the engine case has cooled, check that
the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it
is likely that they will rotate in the engine case when
warm. In this case, the engine case must be renewed.
Press countershaft shaft seal ring
flush, with the open side facing inward.
Position membrane support plate
brane.
Mount and tighten screws@.
Guideline
Screw, mem­ M3
brane
Position membrane support plate
brane.
Mount and tighten screws fi).
Guideline
Screw, mem­ M3
brane
8.
Position oil spray tube
Mount and tighten screw
0
(D
and shift shaft
@)
together with the mem­
1 .5 Nm (1.11 lbf ft)
®
Loctite
8
together with the mem­
1 .5 Nm (1.11 lbf ft)
®
Loctite
O.
in
243 ™
243 ™