Table of Contents
Advertisement
-
Loosen screws (5) . Take out the left fork leg.
C,.
Loosen screws
Take out the right fork leg.
Main work
-
Position the fork legs.
O
✓ Bleeder screws
Info
The compression damping is located in left fork
leg
COMP
(white adjusting screw). The rebound
damping is located in right fork leg REB (red adjusting
screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
8.
-
Tighten screws
Guideline
Screw, top triple
clamp
-
Tighten screws (5) .
Guideline
Screw, bottom triple
clamp
-
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
-
Mount the cable tie(s).
-
Position the brake line, wiring harness, and clamp. Mount and
0.
tighten screws
Finishing work
-
Install the front wheel.
(0
-
Install the headlight mask with the headlight.
-
Check the headlight setting.
6 FORK, TRIPLE CLAMP
are positioned toward the front.
M8
17 Nm (12.5 lbf ft)
M8
15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
p. 109)
(a
p. 103)
(a
p. 148)
C,.
®
243
™
..
17
Advertisement
Table of Contents
