Working On The Left Section Of The Engine Case - Husqvarna FE 450 2014 Repair Manual

18.4.2

Working on the left section of the engine case

Guideline
Screw, bearing
retainer
Mount and tighten oil jet
Guideline
Oil jet, piston
cooling
Mount and tighten oil jet
Guideline
Oil nozzle for con rod
bearing lubrication
Blow compressed air through all oil channels and check that
they are clear.
Finishing work
Install the oil pressure regulator valve.
Remove all remaining dowels.
Remove screw
Remove oil spray tube
Remove screws @).
Remove membrane support plate
Remove countershaft shaft seal ring
Info
The shaft seal ring of crankshaft @ can only be
removed after the crankshaft bearing has been taken
out because of a small external collar.
Remove screws
Remove membrane support plate
Remove any remnants of sealing compound and clean the
section of the engine case thoroughly.
Warm the section of the engine case in an oven.
Guideline
308884-10
1150 °C (302 °F)
Knock the section of the engine case against a level wooden
board. This will cause the bearings to drop out of the bearing
seats.
M5 6 Nm (4.4 lbf ft)
O.
M5 2 Nm (1.5 lbf ft)
8.
M6x0. 75 4 Nm (3 lbf ft)
(� p. 180)
O.
8.
C,
and the membrane.
0
and shift shaft C).
8.
0
and the membrane.
18 ENGINE
®
Loctite 2701
TM
®
Loctite 243
™
177