Removing The Heim Joint - Husqvarna FC 350 2016 Repair Manual

9.19
Removing the heim "oint
9 SHOCK ABSORBER, SWINGARM
-
Measure the diameter of the piston rod.
Piston rod
Diameter
If the measured value is less than the specified value:
Change the piston rod.
-
Measure the run-out of the piston rod.
Piston rod
I
Run-out
G02062-10
If the measured value is greater than the specified value:
-
Change the piston rod.
-
Check the piston rod for damage and wear.
If there is damage or wear:
-
Change the piston rod.
-
Check the piston rings for damage and wear.
If damage or a bronze-colored surface is visible:
-
Change the piston.
G02066-10
Condition
The shock absorber has been removed.
-
Clamp the shock absorber into the vise with soft jaws.
-
Remove the collar bushing of the heim joint.
I
Drift (T1 20) (a
-
Turn the shock absorber and remove the second collar bush­
ing of the heim joint.
-
Press the heim joint against a lock ring using the special tool.
I
Pressing tool (T1207S)
-
Remove second lock ring
� 17.95 mm(� 0.7067 in)
I � 0.02 mm (� 0.0008 in)
p. 296)
(a p. 297)
Q.
67