Table of Contents
Advertisement
7、FRONT FORK COMPONENT
Fig.24 FRONT FORK
COMPONENT
NO.
PART NO.
1
1190100-409051 ZT310-VX right rearview mirror (dark gray)
2
1100100-831000
ZT350-GK front disc brake main pump assembly (φ14)
3
1100100-833000 ZT350-GK front brake handle (CNC)
4
1134300-018000 ZT350-R balance block (aggravated)
5
1244100-042000 ZT250-R right handle bar rubber sleeve
6
1184300-018000 ZT350-X right handle switch (dark gray TFT-750)
7
1250205-031091 GB70.1M6×30(stainless steel)
8
1100100-583000 ZT310-T front brake switch
PROCEDURE:
●Rearview mirror
Hold the mirror stem in one hand, remove the nut ④ with a 13# sleeve, and remove the small pad ③, the
spring ② and the large pad ①. Remove the mirror from the front brake master pump.
●Right handlebar to put rubber sleeve, balance block
Push the rubber sleeve ⑸ with the right handlebar to push forward to expose the upper balance block fixing
hole; use the tool to press the convex parts at both ends of the elastic block on the balance block and pull out
the balance block assembly ⑷, and then put the right handle Remove the rubber sleeve ⑸.
●Right handlebar half cover
Hold the front disc brake main pump ⑵ with one hand, and remove the bolt ⑺ with the 5# hexagon socket
tool. Remove the wire plug connector of the sub switch ⑹ and pull it out.
●Front brake switch replacement
Unplug the brake switch
Remove the bolt ⑤ attached to the front brake main pump and replace the front brake switch. Note that the
boss on the brake switch is aligned with the limit hole at the arrow indication of the front brake main pump.
CAUTION:
●The motorcycle should be fixed after horizontal support.
●Periodically check that the fluid level of the brake fluid is between 3/4 of the observation window.
●Do not flush the cup directly with high pressure water.
●When assembling the balance block, align the protruding parts at both ends of the shrapnel with the fixing
holes on the handle and then insert the direction into the holes.
●The small spacer of the rear view mirror anti-rotation limit slot needs to be aligned with the slot on the
mirror bar bolt.
●The right handlebar refers to the switch to replace the throttle line.
●The joint between the front disc brake main pump and the half cover should be aligned with the right hand
to match the triangle on the switch.
●The old model will be discontinued; the old switch can be replaced directly with the new one.
CHK
Right handlebar component
ADJ
PART NAME
QTY
1
1
1
1
1
1
2
1
84
CAUTION
10N.m
after sale
Advertisement
Table of Contents
