Table of Contents
Advertisement
2、FRAME & ENGINE COMPONENT
Fig.3 FRAME&ENGINE
NO.
PART NO.
1
1251112-002093 M6×30 Hexagon flange bolts (color Zinc)
2
1274100-057095 Flanging bushing φ6.2×φ8.4×3.5＋φ14×1.5
3
1244100-052000 Buffer rubber of flanging bushing (φ8.5×φ14×1)
4
1251112-001093 M6×16 Hexagon flange bolts (color Zinc)
5
1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color Zinc)
6
1250305-009091 GB6187.1 M12×1.25(White Zinc)
GB5187 non-standard bolt M12×1.25×153(10.9
7
1251112-020000
garde/dacromet)
8
1274200-091000 ZT310 water pipe clamp(φ27)
9
1244200-071000 ZT310-V engine outlet pipe
10
1050958-007000 ZT350 EFI high voltage line
PROCEDURE:
●Oil cooler
It is recommended to cover the front pedal support with waterproof and oil-resistant plastic cloth, and then
remove the two bolts⑸ on the right side with 8# sleeve and pull out the two oil pipes.
Remove the three bolts⑷ above the oil cooler with 8# sleeves. Pull out the oil cooler assembly for a certain
distance and remove the bolt⑷ fixing the hydraulic control unit support.
●Radiator middle trim cover
Remove the bolt⑴) at the bottom of the middle trim cover with 8# sleeve, and remove the gasket⑵ and
buffer glue⑶.
●Front pedal support assembly
Fix the head of bolt⑺ with 14# sleeve on the left side and remove nut⑸ with 17# sleeve on the right side.
After grasping the front pedal support assembly, remove the bolt⑺ and remove the pedal support assembly.
●Left side of engine
It is recommended to use a 8# ring wrench with a 72 tooth ratchet wheel corner to remove the bolts⑸ of the
intake manifold. Or loosen the clamp at the air outlet of the air filter and the clamp between the throttle valve
body and the intake manifold; And unplug the high-pressure oil pipe, fuel injector and external pressure
sensor.
Move the hoop⑻ upward by about 30mm with hoop pliers, and then pull out the engine end of the water
outlet pipe⑼. Pull the high-voltage wire⑽ up and out. Unplug the plugs of exhaust pipe and cylinder head
water temperature sensor.
CAUTION：
●The waste oil needs to be collected and returned to qualified institutions. It is forbidden to dump and
pollute the environment and the source of water.
CHK
FRAME&ENGINE 2
ADJ
QTY
PART NAME
1
1
1
4
4
2
2
1
1
1
16
CAUTION
Advertisement
Table of Contents
