Table of Contents
Advertisement
3、INTAKE SYSTEM COMPONENT
Fig.4 INDUCTION SYSTEM
COMPONENT
NO.
PART NO.
1
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
2
1274100-057095 Flanging bushing φ6.2×φ8.4×3.5＋φ14×1.5
3
1244100-052000 Buffer rubber of flanging bushing (φ8.5×φ14×1)
4
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
5
1250303-010093 GB6177.1M6 (environmental color)
PROCEDURE:
●Electrical device box bottom cover
After firmly grasping the bottom cover assembly of the electrical device box, use a 4# hexagon socket to
remove 2 bolts⑴, remove the bushing⑵ and the buffer glue⑶, and remove the 2 bolts⑷ and then remove
them. Note that there is a buckle at the arrow indication, you need to pull down the end near the air filter and
move forward about 15mm at the same time.
Use a 10# sleeve to remove the nut ⑸, and move the charging port base assembly to the side.
●Air filter element
Use a Phillips screwdriver to remove 2pcs screws①,take off the cover②.
Use a flat-blade screwdriver to pry out the middle of the air filter element rubber strip, grab the rubber strip
with your hands and pull it out to remove the filter element. Note that if the filter element card is tight, grab
both sides of the strip and pull it out alternately. Do not use brute force to pull it out to prevent the strip from
breaking.
Prepare a new filter element and sealing ring.
Install the sealing ring into the groove of the filter element and press tightly.
Apply an appropriate amount of oil or grease evenly on both sides of the strip.
Follow the disassembly steps to reassemble all parts.
CAUTION:
●The sealing ring must be assembled in place. Leakage or assembly may not cause dust to enter the engine.
In severe cases, the internal parts of the engine may be damaged.
● Note that the torque should not be too large when locking the Phillips bolt to prevent damage to the parts.
●When flushing the vehicle, be careful not to allow water to enter the air filter. If a small amount enters,
remove the oil pipe and release it. Make sure that there is no water inside the air filter to start the vehicle.
CHK
Replace the air filter element
ADJ
PART NAME
QTY
2
2
2
2
2
22
CAUTION
Advertisement
Table of Contents
