Table of Contents
Advertisement
5、FOOT PEDAL COMPONENT
Fig.1 FOOT PEDAL
COMPONENT
NO.
PART NO.
1
1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color Zinc)
2
1271200-163000 ZT250-S shift lever spline rocker arm (dark gray)
3
1250301-020093 GB6170M6 (environmental color)
ZT250-S shift lever adjusting screw φ10×150(Black
4
1274100-041000
Zinc)
5
1250301-018093 GB6170 M6-LH(color Zinc )
6
1274200-310000 ZT310-VX gear shifter Lever rocker Arm (Dark Grey)
7
1274200-309000 ZT310-VX Brake pedal (Dark Grey)
PROCEDURE:
●Adjust the height of gear shift rod
Use an 10# open-end wrench to loosen the nut ⑶ ,and nut ⑸ respectively. Use 8# open spanner to adjust
the gear shift rod ⑷ adjustment bolt until the height becomes suitable. Then tighten the nuts. If the above-
mentioned method can not adjust the gear shift rod to a satisfying position, take off bolt ⑴ and adjust gear
shift rod spline of rocker arm ⑵ with a straight screwdriver by shoving a little bit the groove in the middle
while dragging it out. Reassemble after the height is suitable. Pay attention to the aligning of the groove in the
middle.
●Adjust the height of brake pedal
Use an 10# open-end wrench to loosen the nut②. Spin the adjustment rod bolt① and adjust the brake pedal
⑺ to 85mm up to the top pedal ⑻. Fix the adjustment rod bolt① and tighten Nut②.
CAUTION:
●Ensure the motorcycle is well supported during manipulation. Avoid falling accident.
●The height of gear shift rod should be ajusted to a suitable range. Otherwise the riding experience would be
influenced.
●The height of brake pedal should be ajusted to a suitable range. Otherwise the durance of braking shoe and
plate would be influenced. In severe case, ineffective braking is possible.
CHK
Adjust the hight of foot pedal
ADJ
PART NAME
QTY
1
1
1
1
1
1
1
42
CAUTION
Advertisement
Table of Contents
