Table of Contents
Advertisement
●Check whether the temperature sensor is damaged
Remove the temperature sensor from the air filter and place it in the ambient temperature (20 ～ 30
℃), and use a multimeter to check whether the resistance of the two pins is between 2726 ～ 1770 Ω.
CAUTION:
●Remove the side cover,seat cushion,fuel tank,etc. in advance.
●Regularly check whether the filter element of the carbon tank and air filter is not ventilated,
otherwise it may cause the oil supply to affect the driving experience.
●It should be no crimp, entanglement and other phenomena.
3、INTAKE SYSTEM COMPONENT
Fig.2 INTAKE SYSTEM
COMPONENT
NO.
PART NO.
1
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
2
1050961-004000 Air filter intake air temperature sensor
3
1274200-088000 ZT310 water pipe clamp(φ10.5)
4
1244200-095000 ZT310-V canister tube adsorption (Φ5 x Φ 11)
5
1051371-002000 Φ59×9 pipe clamp assembly
6
1274200-079000 ZT310 water pipe clamp(φ9)
ZT310-V canister solenoid valve vent manifold (Φ4×Φ
7
1244200-097000
10/Φ5×Φ11)
8
1251300-063093 Plywood M6×11×15(color Zinc)
9
1050954-009000 YH canister solenoid valve
ZT310-V canister electromagnetic valve inlet manifold
10
1244200-096000
(Φ5×Φ11/Φ7×Φ13)
11
1250303-010093 GB6177.1M6 (environmental color)
12
1224100-012000 ZT250-S carbon tank
13
1224300-005000 ZT350-V air filter
PROCEDURE:
●Air filter assembly
Remove the air filter intake air temperature sensor⑵ from the air filter. If the sealant falls off, it needs to be
plugged back to its original position. Remove the clamp ⑸.
Remove the 3 bolts (1) from the 4# inner hexagon, respectively, and remove the air filter assembly from the
car. Need to constantly adjust the angle to take out.
Remove 7 pieces of clamp nuts ⑻.
The oil accumulation pipe ① and the water accumulation pipe ② should be checked and cleaned regularly.
●Carbon Tank Assembly
Use hoop pliers to remove the carbon canister and the 4 pieces of clamps (3) on the solenoid valve end of
the carbon canister, and then pull out the adsorption pipe ⑷, the air outlet pipe ⑺ and the intake pipe ⑽.
Remove all hoops .
Remove the carbon canister ⑿.
●Carbon tank electromangnetic valve
Remove the nut ⑼ with the 10# sleeve; remove the solenoid valve⑺.
●Check the carbon canister solenoid valve:
In case of poor engine performance; Poor idle speed; If the air-fuel ratio is incorrect, check the carbon
canister solenoid valve.
Use a multimeter to measure the resistance between the two inserts of the carbon canister solenoid valve
plug, which should be 35 ± 2 Ω, otherwise the solenoid valve fault can be judged.
CHK
Air filter components 2
ADJ
PART NAME
QTY
3
1
5
1
1
1
1
7
1
1
1
1
1
20
CAUTION
Advertisement
Table of Contents
