Front Right Pedal Mounting Position Adjustment - Zontes ZT350-VX 2022 Service Manual

5、FOOT PEDAL COMPONENT
Fig.2 FOOT PEDAL
COMPONENT
NO. PART NO.
ZT350-V1 rear brake main pump piston push rod
1 1100100-858000
extension rod
GB5789 M10×1.25×25 (10.9 grade environmental
2 1250105-278093
protection color)
PROCEDURE:
●Front right foot position adjustment
Fix the screw ① with 10# open-ended wrench, loosen the nut ② with 14# open-ended wrench, and loosen
the extension rod ⑴ with 10# open-ended wrench.
Break the split pin ③ straight and remove it. Remove the gasket ④ and remove the pin shaft ⑤. Remove the
extension rod (1).
After grasping the front right foot pedal firmly, remove the bolt (2) from the back of the front foot pedal
support with 14# ring wrench.
Install the foot pedal assembly back into a hole position, and assemble the U-joint on the adjusting screw ①
without assembling the extension rod ⑴. Assemble according to the disassembly sequence. Adjust to the
proper position according to the method of adjusting the brake pedal angle.
CAUTION:
●Ensure the motorcycle is well supported during manipulation. Avoid falling accident.
●The muffler should be completely cooled down before disassembly.
●The height of brake pedal should be ajusted to a suitable range. Otherwise the durance of braking shoe and
plate would be influenced. In severe case, ineffective braking is possible.

Front right pedal mounting position adjustment

PART NAME
43
CHK
ADJ
QTY CAUTION
1
1