Main Harness, Dump Switch, Relay, Flasher, Rectifier, Ignition Coil 1.2 Electrical Device Component-2 - Zontes ZT350-VX 2022 Service Manual

CAUTION：
●Do not pull the cable hard when removing the sub-mud switch.
●The replacement of the spark plug and the matters needing attention are described in the
instruction manual.
1、FRAME COMPONENT
Fig.2 FRAME&ELECTRONIC PARTS
COMPONENT
NO. PART NO.
1 1251112-001093 M6×16 Hexagon flange bolts (color zinc)
2 1274300-065000 ZT350-VX front oil pipe bracket
3 1184200-004000 ZT310 horn
4 1274100-017000 ZT250-S cable buckle
5 1224100-037000 Grade 0 flame retardant tie (black 3.6×295)
6 1274100-095000 ZT250-S Flameout switch wire fixing bracket
7 1184100-012000 ZT250-S shut down switch
8 1250205-040095 GB70.1 inner hex bolt M8×16(color Zinc)
9 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc)
10 1251112-002093 M6×30 Hexagon flange bolts (color zinc)
11 1274300-067000 ZT350-V Water outlet pipe anti-wear bracket
12 1186200-013000 ZT310 Rectifier (350W)
13 1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
14 1274300-064000 ZT350-V1 ignition coil bracket
15 1050958-006000 ZT350 ignition coil body
16 1050958-007000 ZT350 EFI high voltage line
17 1224300-110000 Reverse buckle Velcro strap (20×200mm)
PROCEDURE:
●Horn
Take off the plug of horn take the horn ⑶ by one hand, using 8# plum wrench rotate the screw ⑴ by
another hand remove the holder ⑵ then take off the horn.
●Flameout switch
Find and take off the plug of the flameout swich ⑹ press and take off the cable clip ⑷ cut ribbon ⑸ .Using
the 6# inner hexagon tool, remove the bolts ⑻、the holder ⑹ and the flameout switch ⑺ .
●Rectifier
After unfastening the tie strap ⒄ then find and remove the rectifier plug, Using 8# sleeve remove the bolt
⑽, remove the outlet pipe bracket⑾；Using 8#sleeve remove the bolt ⑼ and remove the rectifier ⑵.
●Ignition coil
Pull out the high-voltage wire (16) then end of the spark plug, pull out the end of the ignition coil body and
remove it. Remove the bolt (9) with 8# sleeve and remove the ignition coil body (9). Then using 4# hexagon
socket remove the bolt ⒀ and remove the high-pressure package support (14).
CHK
Electronic parts COMPONENT-2
ADJ
QTY
PART NAME
1
1
1
2
2
1
1
2
3
1
1
1
1
1
1
2
1
9
CAUTION