Table of Contents
Advertisement
3、INTAKE SYSTEM COMPONENT
Fig.1 INTAKE SYSTEM
COMPONENT
NO.
PART NO.
1
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
2
1274100-057095 Flanging bushing φ6.2×φ8.4×3.5＋φ14×1.5
3
1244100-052000 Buffer rubber of flanging bushing (φ8.5×φ14×1)
4
1184300-024100 2.5 Generation PKE Assembly(including induction key)
5
1251300-085093 Non-standard cap nut M6
MSE6.0 controller - ZT184MP (matching split
6
1050958-014000
sensor/Euro V)
7
1274200-268000 ZT310-VX Bosch ECU bracket
8
1251100-102000 Non-standard bolt M6×16 (304 stainless steel)
9
1051371-002000 Φ59×9 pipe clamp assembly
PROCEDURE:
●PKE controller and ECU
For the PKE disassembly method, please refer to the "PKE Assembly" section of "Frame Assembly" in this
manual. For details on how to disassemble the ECU, see the section "Electrical Components-1" in the "Frame
Assembly" of this manual.
●Electrical device box bottom cover
After holding the bottom cover assembly of the electrical device box, remove 2 bolts ⑻ with a 4# hexagon
socket, remove the bushing 2 and buffer glue 3; remove the 2 bolts ⑴ and then remove them. Note that there
is a buckle at the arrow indication, you need to pull down the end near the air filter and move forward about
15mm at the same time.
●Air filter assembly
Unplug the desorption tube and exhaust tube on the left side. After loosening the clamp ⑼, pull out the air
outlet pipe from the throttle valve body.
Refer to the "Electrical Device Assembly-1" section of this manual "Frame Assembly" on the upper right side
to remove the starter relay and bracket.
Unplug the temperature sensor indicated by the arrow in Figure 5.
Unplug the canister solenoid valve.
CAUTION:
●Remove the side cover, seat cushion,fuel tank, etc. in advance.
●Do not pull the cable hard when unplug the connector.
●Always keep the disc brake oil cup cover facing up.
CHK
Air filter components 1
ADJ
PART NAME
QTY
7
4
4
1
2
1
1
2
1
19
CAUTION
Advertisement
Table of Contents
