Table of Contents
Advertisement
6、COOLING SYSTEM COMPONENT
Fig.5 COOLING SYSTEM
COMPONENT
NO.
PART NO.
1
1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color Zinc)
2
1251112-003093 M6×45 Hex flange surface 9.8 bolt (color Zinc)
3
1274200-079000 ZT310 water pipe clamp(φ9)
4
1244200-069000 ZT310-V auxiliary water tank leakage pipe
5
1224300-030000 ZT350-V vice water tank
6
1274200-088000 ZT310 water pipe clamp(φ10.5)
7
1244200-070000 ZT310-V auxiliary water tank is connected with water p
8
1251300-057093 Non-standard nut M10×1.5(Dacromet)
9
1274200-184000 ZT310-V auxiliary water tank bracket
10
1251100-132003 Non-standard bolt M10×1.5×80 (Dacromet)
PROCEDURE:
●Vice water tank assembly
Remove the bolts ⑴ and ⑵ with 8# sleeve,pull the vice water tank assembly out of the gap.
After wearing the waterproof rubber gloves, put the sub tank assembly upside down (the sub water tank
cover down) into a plastic container.
After clamping the hoop ⑶ with pliers, pull the water pipe out of the main tank and remove the hoop ⑶.
Vent the coolant in the secondary tank.
Clamp the clamp on the leak pipe ⑷ with pliers and pull it out. Subsequent production of motocycles will
reduce the clamps for leak pipe.
Clamp the hoop ⑹with pliers and pull the water pipe ⑺ out of the sub tank ⑸, then remove the hoop ⑹.
●Sub water tank bracket.
If it is necessary to remove the auxiliary tank bracket, fix the bolt ⑽ with 14# sleeve then remove the nut ⑻
with 14# sleeve .
Remove the sub tank bracket ⑼ after pulling out the bolt ⑽.
CAUTION:
●Disassembling the cooling system while the motorcycle is hot is prohibited. Wait until the engine and
muffler cool down thoroughly for the manipulation.
●Cooling liquid should be collected and hand over to qualified facilities for further treatment. Do not pour
the oil anywhere and avoid pollution of environment and water source.
CHK
Vice water tank components
ADJ
PART NAME
QTY
1
1
1
1
1
1
1
1
1
1
56
CAUTION
Advertisement
Table of Contents
