Table of Contents
Advertisement
4、REAR WHELL COMPONENT
Fig.5 Rear wheel, swinging
arm component
NO.
PART NO.
1
1251300-071000 Non-standard nut M12×1.5 (chrome plated)
2
1230100-565000 180/55ZR17 CM-S3(73W) TL E4
ZT350-V1 single rocker arm rear wheel (MT5.5×
3
1094300-009000
17/black)
4
1260100-238000 ZT310-R1 rear wheel rim sign spring
5
1210142-000100 ZT310-R1 single rocker black rim sign
6
1184300-034000 ZT350 tire pressure sensor (M8 straight head)
PROCEDURE:
●Rear wheel assembly
Remove the 5 nuts with a 200N torque wrench and a 19# gauge sleeve.
Support the vehicle horizontally and let the rear wheels leave the ground.
Remove the rear wheel assembly.
Extend the tool from the left to remove the rim sign ⑸ from the rim and remove the plaque spring ⑷ from
the placard⑸.
●Bosch EFI: Tire pressure sensor
Remove the tire pressure sensor ⑹ built-in valve cap ① Use a tool to release the air, Then use a professional
tire puller to remove the rear tire ⑵. Be careful to avoid the tire pressure sensor. Finally, use a 12# torx
wrench to remove the valve nut ② and the flat washer ③, and then remove the tire pressure sensor.
●Maintenance
Tire: Check regularly the tire on cracks and air pressure.If the tire is ware to the marker, change the tire with
same specification. See details in user manual. Ingradiant of tire include semi hot melt rubber. Area with too
high temperature is not suitable. If temparature of outdoor is too low, storing the motorcycle in warm place or
indoor is suggested in order to avoid frost crack. Normal temperaturestandard 280kPa.
Rim: Check if the rim has deformation or crack. Support the rim horizontally and check if it can rotate
smoothly.
Disc brake plate: Thickness can not be less than 4mm. If not, change it.
CAUTION:
●Be careful while disassembling the tire and rim in case of damages on the components.
●After changing the tire, check air proof performace and dynamic balance.
●It should not be used because the tire self replenishment may block the air hole of the tire pressure
monitoring sensor, resulting in inflation difficulty or tire pressure monitoring failure.
●Not enough tire pressure can cause abnormal wear and tare. Too high pressure in summer might have
possibility of tire bursting.
CHK
Rear wheel component
ADJ
PART NAME
QTY
5
1
1
1
1
1
27
REMARKS
110N.m
Advertisement
Table of Contents
