Bolt-On External Fall Arrest; Inspection Before Use - JLG 1200SJP Operation And Safety Manual

SECTION 6 - ACCESSORIES
6.7

BOLT-ON EXTERNAL FALL ARREST

The bolt-on external fall arrest system is designed to provide a lan-
yard attach point while allowing the operator to access areas outside
the platform. Exit/Enter the platform through the gate area only. The
system is designed for use by one person.
Personnel must use fall protection at all times. A full body harness is
required with lanyard not to exceed 6 ft. (1.8 M) in length, that limits
the maximum arrest force to 900 lb (408 kg).
External Fall Arrest System capacity is 310 lb (140 kg) - one (1) person
maximum.
Do not move platform during use of the external fall arrest system.
DO NOT OPERATE ANY MACHINE FUNCTIONS WHILE OUTSIDE OF PLATFORM. BE
CAREFUL WHEN ENTERING/EXITING THE PLATFORM AT ELEVATION.
6-14
IF THE EXTERNAL FALL ARREST SYSTEM IS USED TO ARREST A FALL OR IS OTHERWISE
DAMAGED, THE ENTIRE SYSTEM MUST BE REPLACED AND THE PLATFORM FULLY
INSPECTED BEFORE RETURNING TO SERVICE. REFER TO THE SERVICE MANUAL FOR
REMOVAL AND INSTALLATION PROCEDURES.
THE EXTERNAL FALL ARREST SYSTEM REQUIRES AN ANNUAL INSPECTION AND CERTI-
FICATION. THE ANNUAL INSPECTION AND CERTIFICATION MUST BE PERFORMED BY A
QUALIFIED PERSON OTHER THAN THE USER.

Inspection Before Use

The external fall arrest system must be inspected before each use of
the aerial work platform. Replace components if there are any signs
of wear or damage.
31215054