Towing, Lifting, And Hauling; Maintenance; Maintenance Hazards - JLG 1200SJP Operation And Safety Manual

1.4

TOWING, LIFTING, AND HAULING

• Never allow personnel in platform while towing, lifting, or
hauling.
• This machine should not be towed, except in the event of
emergency, malfunction, power failure, or loading/unloading.
Refer to the Emergency Procedures section of this manual for
emergency towing procedures.
• Ensure boom is in the stowed position and, if equipped, the
turntable locked prior to towing, lifting or hauling. The plat-
form must be completely empty of tools.
• When lifting machine, lift only at designated areas of the
machine. Lift the unit with equipment of adequate capacity.
• Refer to the Machine Operation section of this manual for lift-
ing information.
31215054
SECTION 1 - SAFETY PRECAUTIONS
1.5

MAINTENANCE

This sub-section contains general safety precautions which must
be observed during maintenance of this machine. Additional pre-
cautions to be observed during machine maintenance are
inserted at the appropriate points in this manual and in the Ser-
vice and Maintenance Manual. It is of utmost importance that
maintenance personnel pay strict attention to these precautions
to avoid possible injury to personnel or damage to the machine
or property. A maintenance program must be established by a
qualified person and must be followed to ensure that the
machine is safe.

Maintenance Hazards

• Shut off power to all controls and ensure that all moving parts
are secured from inadvertent motion prior to performing any
adjustments or repairs.
• Never work under an elevated platform until it has been fully
lowered to the full down position, if possible, or otherwise
supported and restrained from movement with appropriate
safety props, blocking, or overhead supports.
• DO NOT attempt to repair or tighten any hydraulic hoses or fit-
tings while the machine is powered on or when the hydraulic
system is under pressure.
• Always relieve hydraulic pressure from all hydraulic circuits
before loosening or removing hydraulic components.
1-11