JLG 1200SJP Operation And Safety Manual page 66

SECTION 4 - MACHINE OPERATION
2. Pull the Power/Emergency Stop switch out.
3.
Push the Engine Start switch until engine
starts.
ALLOW ENGINE TO WARM-UP FOR A FEW MINUTES AT LOW SPEED BEFORE APPLYING
ANY LOAD.
4. After engine has had sufficient time to warm up, shut engine
off.
5. Turn Platform/Ground Select switch to the
Platform position.
6.
From Ground Control Console, pull Power/
Emergency Stop switch out.
4-6
7. From the Platform Control Console, pull the
Power/Emergency Stop switch out.
8.
Push the Engine Start switch until engine
starts.
NOTE:
Footswitch must be in released (up) position before starter will
operate. If starter operates with footswitch in the depressed posi-
tion, DO NOT OPERATE MACHINE.
31215054