Capacity Specifications (Australia Only); Safety Precautions; Preparation And Inspection; Operation - JLG 1200SJP Operation And Safety Manual

SECTION 6 - ACCESSORIES

Capacity Specifications (Australia Only)

Max. Capacity in Racks
80 kg
Max. Length of Material in Racks: 6.0 m
Min. Length of Material in Racks: 2.4 m

Safety Precautions

REDUCE PLATFORM CAPACITY BY 100 LB (45.5 KG) WHEN INSTALLED.
WEIGHT IN RACKS PLUS WEIGHT IN PLATFORM MUST NOT EXCEED RATED CAPACITY.
THE MAXIMUM LOAD IN THE RACKS IS 180 LB (80 KG) EVENLY DISTRIBUTED
BETWEEN THE TWO RACKS.
THE MAXIMUM LENGTH OF MATERIAL IN RACKS IS 20 FT (6.1 M).
6-4
Max. Platform Capacity
(With Max. Weight in Racks)
184 kg
• Ensure no personnel are beneath the platform.
• Do not exit platform over rails or stand on rails.
• Do not drive machine without material secured
• Return racks to the stowed position when not in use.
• Use this option only on approved models.

Preparation and Inspection

• Ensure racks are secured to the platform rails.
• Replace torn or frayed tie-down straps.

Operation

1. To prepare racks for loading, remove locking pins, rotate
each rack 90 degrees from stowed to working position, then
secure with locking pins.
2.
Loosen and remove tie-down straps. Place material on racks
with weight evenly distributed between both racks.
3.
Route the tie-down straps at each end across loaded mate-
rial and tighten.
4. To remove material, loosen and remove tie-down straps,
then carefully remove material from racks.
NOTE:
Reinstall tie-down straps across any remaining material before
continuing machine operations.
31215054