HP jetdirect 175x Administrator's Manual page 85

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

Table 3.4
Telnet Commands and Parameters (5 of 18)
svr-auth-pass
svr-auth-id
wpa-auth-type
psk-passphrase
dynamic-encrypt
ENWW
Specify a password for server-based authentication. Up to
128 alphanumeric characters may be used.
Specify the CA certificate character string that will be used
to identify and validate the authentication server. This string
will be compared to an identification string received from the
authentication server. For string comparison, you can
specify whether an exact match is required:
RIGHT_MOST (default): The string entry will be compared
to the right-most characters in the CA certificate string.
USE_EXACT: The string entry must exactly match the
authentication server's string.
This command is not compatible with the Shared Key
authentication option in the auth-type command. Use this
command to specify a supported EAP authentication type:
802.1x: Select this option on an EAP network that uses an
authentication server. Use the server-auth command to
specify the EAP/802.1x protocols used on your network. Use
the dynamic-encrypt command to specify a dynamic
encryption option.
PSK: Select this option on EAP networks where an
authentication server is not used. Instead, a Pre-shared key
provides device authentication. A Pre-shared key is
generated when you specify a network pass-phrase using
the psk-passphrase command. The dynamic-encrypt
command should be set to the Robust option.
Specify a pass-phrase that is used to generate a network
Pre-shared key. A pass-phrase must be from 8 to 63 ASCII
characters in the hexadecimal range 21 through 7E
(characters 0-9, a-z, A-Z and numerous special characters
including !, @, #, $, %, ^, &, (, ), _, +, =, -, {, }, [, ], \, /, ", <,
>, ?, ", ', ~).
Select a supported dynamic encryption option:
Basic: Dynamic WEP encryption is supported.
Robust: Dynamic Wi-Fi Protected Access (WPA) and WEP
encryption protocols are supported.
Use the wpa-auth-type command to select a compatible
EAP authentication type:
G
For EAP/PSK authentication, the print server should use
Robust encryption (WPA encryption protocols).
G
For EAP/802.1x authentication (LEAP only), the print
server should use Basic encryption.
G
For EAP/802.1x authentication (PEAP, TLS, TTLS only),
the print server may use either Basic encryption or
Robust encryption depending on your network.
Dynamic encryption protocols are under the control of the
authentication server and also must be supported by the
Access Point.
TCP/IP Configuration 85

Advertisement

Table of Contents
loading

Table of Contents