HP jetdirect 175x Administrator's Manual page 197

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

7. Is your protocol enabled on the HP Jetdirect print server?
Check the status of your protocol on the Jetdirect configuration
page. See
Chapter 9
(On TCP/IP networks, you can also use the embedded Web
server to check status of other protocols. See
8. Is there an error message in the protocol's section on the
Jetdirect configuration page?
See
Chapter 9 "HP Jetdirect Configuration
error messages.
9. If you are using Token Ring, is the data rate correct?
Check the Jetdirect configuration page for the current settings.
If they are incorrect, refer to the Token Ring settings in the print
server hardware installation guide.
10. If you are using Apple EtherTalk, does the printer appear in the
Chooser?
Verify network and HP Jetdirect settings on the Jetdirect
I
configuration page. See
configuration page.
Confirm the network settings for the printer using the printer
I
control panel (for printers with control panels).
See the troubleshooting section in the online help for the
I
HP LaserJet Utility.
Verify the printer has the PostScript option installed.
I
11. If you are on a TCP/IP network, can you use Telnet to print
directly to the printer?
Use the following Telnet command:
telnet <IP address> <port>
where <IP address> is the IP address assigned to the
HP Jetdirect print server and <port> is 9100. (HP Jetdirect
data port 9101 or 9102 can also be used for ports 2 or 3
respectively, of a Jetdirect multiport external print server.)
In the Telnet session, type in data and press Enter. The data
should print to the printer (a manual form feed may be
required).
ENWW
for information on the configuration page.
Chapter 9
Troubleshooting the HP Jetdirect Print Server 197
Chapter
Page" for a list of
for information on the
4.)

Advertisement

Table of Contents
loading

Table of Contents