HP jetdirect 175x Administrator's Manual page 240

Table 9.12 Error Messages (9 of 11)
Error Code and
Message
46 INVALID SERVER
ADDRESS
47 INVALID TRAP
DEST ADDRESS
48 CF ERR - FILE
INCOMPLETE
49 CF ERR - LINE TOO
LONG
4A CF ERR -
UNKNOWN
KEYWORD
4B CF ERR - MISSING
PARAMETER
4C CF ERR - INVALID
PARAMETER
4D CF ERR - ACCESS
LIST EXCEEDED
4E CF ERR - TRAP
LIST EXCEEDED
4F TFTP REMOTE
ERROR
50 TFTP LOCAL
ERROR
51 TFTP RETRIES
EXCEEDED
52 BAD BOOTP/DHCP
REPLY
ENWW
Description
The TFTP server IP address specified for the HP Jetdirect
print server (through BOOTP) is an invalid IP address for
specifying a single node. Check your Bootptab file for proper
entries.
One of the SNMP trap (Trap PDU) destination IP addresses
specified for the HP Jetdirect print server (through TFTP) is
an invalid IP address for specifying a single node. Check
your TFTP configuration file.
The TFTP configuration file contained an incomplete last
line that did not end in a newline character.
A line being processed in the TFTP configuration file was
longer than the HP Jetdirect print server could accept.
A TFTP configuration file line contained an unknown
keyword.
A line in the TFTP configuration file was missing a required
parameter.
A line in the TFTP configuration file contained an invalid
value for one of the parameters on that line.
The TFTP configuration file specified too many access list
entries using the "allow:" keyword.
The TFTP configuration file specified too many trap
destination list entries using the "trap-destination:" keyword.
The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the remote host
sending a TFTP ERROR packet to the print server.
The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the local print server
encountering some form of inactivity timeout, or excessive
retransmissions situation.
The overall retrying of the TFTP transfer of the configuration
file from the host to the HP Jetdirect print server has
exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the
HP Jetdirect print server received. The reply either had
insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP/DHCP server port (67/udp).
HP Jetdirect Configuration Page 240